Before proceeding, you should assign numbers to each of the machines in the laundry room/building.
It is highly recommended that you place number labels on each washer and dryer machine.
​

Set the DIP switch, on the back of the reader, to number the reader.
​
See our Reader DIP Switch settings article for instructions on how to set the reader's dip switches
​

Splice the GREEN and WHITE wires, from the provided reader cable harness, to this harness inside the machine
(it doesn't matter which reader wires are spliced to which machine wires):
​
​

​
And the coin drop's wiring will be coming from CN2 on the machine's control board:
​

​
If you have this variant of these machines, you'll connect the reader's GREEN and WHITE wires (reader's start wires) to the BROWN and YELLOW wires that are seen on the machine's coin drop harness (it doesn't matter which reader wire goes to which machine wire)
​

Note: depending on which above configuration you use, the card reader's Control Type may need to be changed (Control Type [04] or Control Type [12])
If your machine is not receiving the pulse from our card reader, contact our support to have the Control Type of the card reader adjusted

Use the provided external power supply to provide power to the card reader
You can connect the AC side of the 12V power supply, to 110Vac inside the machine.
​

Mount the reader to the machine, and Activate it with this store location's Activation Card:
​

​
​