The Penny Coin Drop Blocking Mounting plate is packaged in the following manner.
Remove the coin drop mechanism from the machine and puncture the overlay in the locations highlighted below. Trim as needed until the qty 4x 1/4-20 stud on the mounting Bracket fit through the holes and the Bracket sits flush with the front face of the machine.
Mount the Penny device to the Bracket in the following manner using the standard screws provided with the Penny.
Snake the harness out through the left open coin slot.
Connect the harness to the Penny and install the backet flush against the machine.
Secure the Bracket with the qty 4x supplied 1/4-20 nuts.
Completed install:
