This article is applicable to Maytag machines without electronic controls, such MFR80PCAVS
Required parts
Reader
Cable Harness
12V Power supply
High voltage relay
Installation Steps
Step 1: Turn Machine Power Off
Step 2: Remove coin-drop
Step 3: Number the reader using the DIP switch
Step 4: Connect the High Voltage Relay
The output wires of the High Voltage Relay should connect across the wire going to J2.10 (wire 5) and Neutral (wire 21)
Pricing
Vend pricing is set on the reader using the LaundroPortal. The reader sends one pulse. Configure the machine to start the cycle with one pulse (e.g set cycle cost to $0.25)