Before proceeding, you should assign numbers to each of the machines in the laundry room/building. It is highly recommended that you place number labels on each washer and dryer machine.
​
​

Set the machine type and number using the DIP switch on the back of the reader
​

​
See DIP switch settings page for more details.
​

Turn machine power OFF!
​

Remove the coin drop if present
​

Connect the signal connectors
​

​

Connect Power
Newer Encore dryer models should be provided with a short power cable inside the drum of the machine:
​
​

​
Connect this cable between the dryers control board and the mating 2-pin connector on the cable harness from the reader.
​
If you're unable to find this cable, you can get 12V from the dryer control. You can splice into the wires coming from the connector on this machine as follows:
​
Splice the blue wire from the reader cable harness to the wire representing GND.
Splice the red wire from the reader cable harness to the wire representing 12V
​
​
​

Proceed to secure the reader to the machine using the nuts
​

Activate the card reader with the Store's Activation Card:
​

​
​