This article walks through how to safely remove the 80mm thermal printer module from a Sunmi T3 80mm POS so the unit can be replaced. Follow it when Cents has shipped a replacement printer and the old module needs to come out before the new one goes in.
Video walkthrough of the full removal: Sunmi T3 80mm Printer Removal
Sunmi product reference: T3 & T3 80MM Documentation
When to use:
Cents has sent a replacement 80mm printer module and the failing one needs to come out.
The printer is jamming, printing blank or faded receipts, or not responding, and Cents Support has approved a hardware swap.
You need to inspect the print head, print board, or paper roller for damage.
Before you start, you'll need:
A Phillips-head screwdriver.
A plastic pry tool (the video calls this a crowbar). A spudger or plastic opening pick works.
A clean, dry, well-lit workspace with room to lay parts and screws out in order.
The replacement 80mm printer module shipped from Cents.
The T3 powered off, unplugged from AC, and with the paper roll removed.
Open the housing and detach the print head
Work slowly and keep each screw with the part it came from. The ribbon cables inside are fragile, and pulling anything by the wire will damage the printer.
Raise the home screen to its maximum tilt angle. This gives you clearance to work on the printer housing underneath.
Remove the home screen hinge cover using the plastic pry tool. Slide the tool along the seam and pop the cover off.
Open the printer door cover by pressing the release latch and swinging it open.
Remove the upright cap from the top end of the upright post using the pry tool.
Unscrew the two screws that hold the print head.
6. Raise the print head from the bracket where you just removed the screws, then lift one end from the left side and slowly take it out.
Do not pull. The print head is still attached by wiring. Pulling will damage the harness and the ribbon cable.
7. Disconnect the power cord on the print board.
8. Unlatch the print data cable connector on the print board. Flip the small locking tab up first, then slide the ribbon cable out. Do not pull the ribbon directly.
Remove the print board
Unscrew the 3 screws holding the print board.
Disconnect all remaining cables on the print board.
Lift the print board out.
Remove the press block and paper roller
Unscrew the 5 screws holding the press block.
Remove the press block.
Unscrew the 2 retaining screws from the press paper roller.
Remove the press roller and the rest of the printer assembly.
Disassembly complete. The old printer module is now fully removed. Install the replacement by reversing these steps, confirming each ribbon cable is fully seated and each lock tab is flipped down before closing the housing.
Video walkthrough
Watch the full removal from start to finish. The video is the authoritative source for what each part looks like and the order of operations.
Need assistance?
Feel free to text our Cents Support team at 888-302-8809.

