Cents

Most machines will have a male 2-pin connector coming from the control board to provide 24VAC power.

1. Plug the male 2-pin connector coming from the control board to the AC input of the 24VAC/12VDC adapter
2. Plug the male 2-pin connector from the DC output of the 24VAC/12VDC adapter to the female 2-pin connector on the Cents Harness

Insert the 7-pin plug from the Cents harness to the 7-pin connector H3 on the machine control board Coin Drop Connection

1. Disconnect the 3-pin connector coming from the coin drop. 
2. Connect the male 3-port connector from the Cents harness to the female 3-port connector coming from the coin drop. 
3. Connect the female 3-port connector from the Cents harness to male 3-port connector coming from the control board. 
4. Note: there are two male 3-port connectors (one for $1 coins and one for $0.25 coins). Ensure you use the one previously connected to the coin drop.

Using the adhesives on the back of the Pulse, attach it to the side of the machine with the antenna pointed into open air. Connect the Cents harness to the Pulse.

1. Power off and open the machine
2. Most machines will have a male 2-pin connector coming from the control board to provide 24VAC power. 
 
 
 1. Plug the male 2-pin connector coming from the control board to the AC input of the 24VAC/12VDC adapter
 2. Plug the male 2-pin connector from the DC output of the 24VAC/12VDC adapter to the female 2-pin connector on the Cents Harness
3. Insert the 7-pin plug from the Cents harness to the 7-pin connector H3 on the machine control board Coin Drop Connection
 1. Disconnect the 3-pin connector coming from the coin drop. 
 2. Connect the male 3-port connector from the Cents harness to the female 3-port connector coming from the coin drop. 
 3. Connect the female 3-port connector from the Cents harness to male 3-port connector coming from the control board. 
 4. Note: there are two male 3-port connectors (one for $1 coins and one for $0.25 coins). Ensure you use the one previously connected to the coin drop.
4. Using the adhesives on the back of the Pulse, attach it to the side of the machine with the antenna pointed into open air. Connect the Cents harness to the Pulse.
5. Power on the machine