Skip to main content

Pulse Centurion Washer Install Guide

Euri Romanov avatar
Written by Euri Romanov
Updated this week
  1. Power off the machine and open the machine

  2. Insert serial jumper into connector H6 on the machine control board

  3. Insert the 7-pin plug from the Cents harness to the 7-pin connector H3 on the machine control board

  4. Coin Drop Connection

    1. Disconnect the 3-pin connector coming from the coin drop.

    2. Connect the male 3-port connector from the Cents harness to the female 3-port connector coming from the coin drop.

    3. Connect the female 3-port connector from the Cents harness to male 3-port connector coming from the control board.

    4. Note: there are two male 3-port connectors (one for $1 coins and one for $0.25 coins). Ensure you use the one previously connected to the coin drop.

  5. Connect the 2-pin power adapter to the open ports on H1. Ensure power and GND are connected to the appropriate ports as pictured. Ensure the 24 VAC to 12 V adapter is used.

  6. Connect the 2-pin female connector on the Cents harness to the 2-pin male connector coming from the power adapter connected to H1.

  7. NOTE: there is another 2-pin connector on most machines that is in the bundle of wires near the coin drop. This can also be used.

  8. Using the adhesives on the back of the Pulse, attach it to the side of the machine with the antenna pointed into open air. Connect the Cents harness to the Pulse.

  9. Power on the machine

Did this answer your question?