This installation note covers Laundrylux Hero (or Encore Pro) Washers. The reader uses serial control to communication with the machine.
Parts
Reader (with Generic Relay board - ASSY-02-02-10)
Cable harness
Installation
Before proceeding, you should assign numbers to each of the machines in the laundry room/building. It is highly recommended that you place number labels on each washer and dryer machine.
Set the DIP switch to number the reader. See Reader DIP Switch settings
Connections
Simply snap together the small 2-pin connectors (for power) and the larger white connector (power)
Enable serial communication on the washer
Enter Service Mode -> CONFIGURATION -> CONNECTION SETTINGS. And set SERIAL PAUMENT DEVICE to ENABLED
Proceed to secure the reader to the machine
Activate the card reader with the Store's Activation Card
Vend Pricing
Set the pricing on the reader using the LaundroPortal.
Troubleshooting
If the reader is show "No Comm with Machine", you may need to update the firmware on the washer using the USB drive that came with the washer.