Set the machine type and number using the DIP switch found on the reader circuit board:
​
​

See DIP switch settings page to understand how to configure DIP switch positions to set the machine type (washer or dryer) and number.
​
​

Turn machine power OFF!
​
​

Remove the coin drop if present
​
​

Connect the the cable harness to the RS485 port on the HMI (right behind the touch display)
​
This is Port X7. It is the second port from the top on the left (if facing the front of the touch display)
​
​

​
​

Secure the reader to the front. You may need to drill a few small holes on the front panel
​
​

Power ON the machine
​
​

Enable serial communication on the washer
​
Go into the settings menu of the washer by swiping left to right across the top. Then Enable the Internal Sapphire setting.
​
​
​

Activate the reader using the provided Activation Card:
​
​

​
​