Skip to main content
All CollectionsHardwareScales
How To Set Up Your Scale Adapter Connection With a CAS Model
How To Set Up Your Scale Adapter Connection With a CAS Model
Jessie Guerra avatar
Written by Jessie Guerra
Updated over a year ago

Setting up the Scale Adapter with a CAS Model Using a CAS Scale model? Learn the additional steps required for setup.

If you are you using a CAS scale, you will need set the scale to continuous mode for the Cents Scale Adapter to function properly.

  1. Make sure that power is OFF. While pressing the ZERO key, press the power key. The display shows “U Set”.

  2. Press the ZERO key until you see either “noSnd”, “K-Send”, “S-Send”, “U-Snd”, or “C-Send”. It may show any of these depending on your current settings.

  3. We want to be in “U-Snd” mode, so press the TARE key until the display reads “U-Snd”

  4. Press the ZERO key to set the mode to “U-Snd”

  5. Press the ZERO key until the display returns to normal. Several other settings will come up but just keep pressing ZERO as these settings are not important to us.

  6. To make sure everything is set correctly, place something on the scale. You should NOT hear a beep when the value stabilizes. The ‘O’ in the top loft of the display will tell you if the weight is stable.

  7. If the scale beeps, turn off the device and go through the steps again, being sure to follow the instructions carefully.

Did this answer your question?

Did this answer your question?