Skip to main content
All CollectionsCents ConnectPenny & Pulse Install Guides
Pulse Dexter C-Series Washer Install Guide
Pulse Dexter C-Series Washer Install Guide
Euri Romanov avatar
Written by Euri Romanov
Updated over 3 months ago

  1. Power off the machine and open the machine.

  2. Identify the 6-pin male header labeled SERIAL COM on the Dexter control board.
    ​

  3. Using the 30-00963 harness, plug the female 6-pin connector into this header.

  4. Identify the 24VAC transformer. There will be two red/orange wires at its output.
    ​


    ​

  5. Splice onto 24AC output of the transformer. Connect to the AC input of the provided AC-DC Adapter. Connect the 30-00899 connector to the DC output of the AC-DC Adapter.
    ​

  6. Plug in the male 2-pin connector from the 30-00899 harness into the female 2-pin connector on the 30-00963 harness.

  7. Using the adhesives on the back of the Pulse, attach it to the back of the machine with the antenna pointed into open air. Connect the Cents harness to the Pulse. Ensure the LEDs on the Pulse are illuminated.
    ​

Did this answer your question?